Motorsport subcontractor h2m has opted for a new sliding head package that allows rapid setups for lower volume production.
Joint managing directors and owners, father and son team Andy and Martin Forryan wanted a replacement for an older machine and opted for a Cincom M32-VIIILFV with Citizen's Alkart Wizard programming system. The wizard assists and simplifies the creation of even complex cycles using a built-in code library, reference material and diagrams.
Sharing some detail of their deliberations, Martin said, "Alkart Wizard is an inexpensive option. We use it to prepare programs and prove them out off-line for virtually every sliding-head part we produce. Only the occasional simple component is programmed directly at the control.
"Even complicated components take just 30 to 40 minutes to program in Alkart and it then takes 15 to 20 minutes to high-speed check the cycle virtually in the wizard, so a new job is always up and running in under an hour."
3,000-off is a large run for sliding-head turned parts at h2m, while production of batches of relatively simple components up to 500-off is typical for unattended overnight running. However, trickier jobs are completed during day shifts in batch sizes as low as 10-off, so speed of programming is essential to minimise machine downtime. Otherwise the reduction in productivity would lower profitability.
Jack Simms, setter-operator of the M32-VIIILFV added, "Basically, the Alkart Wizard is a CAM system and post processor for the Cincom lathe all in one. It is very quick to use and the next program is always ready as soon as the previous batch has finished.
"We also like the LFV (low frequency vibration) chip breaking software in the lathe control, which is built into the operating system rather than being macro-based.
"It works at both spindles and is an absolute dream. We use it on most jobs, mainly for G71 roughing cycles which tend to produce stringy swarf, particularly when machining heat-treated stainless steels and titanium.
"LFV is programmed by G-code to turn on when roughing starts and off again when it finishes and is typically used for one-quarter of a cutting cycle. You always end up with short chips, so there are no ribbons tangled around the tool and part."
The machine was supplied with a kit that allows oversize bar up to 35 mm diameter to be fed into the machine for sliding-head mill-turning. A further benefit is the ability to remove the guide bush, enabling parts up to 2.5D to be machined more accurately from less expensive bar, in multiple passes if desired, while reducing remnant length three-fold. Neither facility had been used by the time the firm was visited in mid-March 2024, by which time 74 different components had been produced on the M32-VIIILFV.
The machine has rapidly proven to be a key facility on the turning side of the subcontractor's business, supplementing CNC milling, much of it automated, as well as both die-sink and wire-cut electric discharge machining. The latest lathe acquisition is helping to further the subcontractor's success, which is already evident from its current headcount of 49, despite the company having been established by Andy Forryan as recently as 2015. Today, 80% of the firm's throughput is destined for the motorsport sector, but aerospace work has started to grow and the company is already an established tier-two supplier.